Description
-
- Comes with high quality rubber OE style bushings for maximum flexibility
- Made from HSLA (High Strength Low Alloy) Steel, 5mm (0.2″) wall thickness, and powder coated black
- Oversized adjusters and rod thickness for maximum strength and durability with double-nut locking feature
- Zinc plated, then powder coated black, for the ultimate finish and protection
—
These are adjustable rear upper control arms, to be used on any vehicle lifted or not, up to 3″ of lift. This kit comes with both upper arms and pre-installed rubber bushings. The rubber bushings allow for more flex of the rear axle, and will also be noise and maintenance free. These adjustable arms will allow you to properly set your rear pinion angle due to adding a lift, while also adding strength over the stock arms. Suitable also for long travel rear suspension setups.
Instructions for use: Set initial length to the same as factory arms, then check pinion angle, then adjust at 1/2″ increments until your pinion angle is set properly. Adding too much length could lead to driveline vibrations.
